02-805-5888   info@summitindustech.com

02-805-5888
info@summitindustech.com

ALL CATEGORY

PRODUCT

Silicone Belt Heater

Brand : SAKAGUCHI
Category : Heaters
SKU : Silicone Belt Heater

◼ Features

● 【Homogeneous heating】
Silicone belt heaters are planar shaped on one side resulting in a homogeneous heating surface, which provides excellent heating properties.
● 【Wide wattage range】
The heater can be custom-built over a wide wattage range, from low（W/m）to as high as an upper temperature limit of covering material.
● 【Wide range of applications】
The heater is designed for heating or keeping heat at a temperature range between low and medium allowing you to use it in a wide range of applications.
 

◼ Types

| SCH types

Reference data
Material Heat-resistant silicone rubber
Operating temperature(*) -50℃ ~ 180℃
Insulation resistance DC500V 100MΩ or more
Dielectric strength 150V or less：1000VAC/1min,
Over 150V：1500VAC/1min
Tensile strength at joint 30N(3.06kgf)

* The operating temperature is for a standard usage may vary depending on operating environments

Configure of standard types

All products listed are available in different voltages.

Length Voltage Wattage Wattage/1m Product code
1,000mm 100V 30W 30W/m SCH13
2,000mm 100V 60W 30W/m SCH16
3,000mm 100V 90W 30W/m SCH19
1,000mm 200/100V 30/7.5W 30/7.5W/m SCH23
2,000mm 200/100V 60/15W 30/7.5W/m SCH26
3,000mm 200/100V 90/22.5W 30/7.5W/m SCH29

◼ Reference data

Temperature characteristics

Configure of standard types

* Temperature characteristic graph shown above is reference measured with the product being suspended at ambient temperature.

◼ Precautions when using this product

●This product is for industrial use only.
●Use the product under control with a temperature controller.
●The product is for indoor use only and not waterproof. Keep out of water or any solutions.
●Do not twist the product around workpiece with excessive traction and/or with itself being crossed over or overlapped since it may cause a premature wire breakage or an abnormal overheating, although, when low in degree of adhesion to workpiece, it results in lowering heat transfer coefficient.
●Do not bend the heater to excess as it may cause a crack in the heater.
●Do not bend the lead wire joint to an acute angle or squash it as it may cause an electric shock or a premature wire breakage.

Share

Related Products