◼ Features

● 【Hight heat resistance】
This heater operates in environments as high as 250℃ since special polyimide films providing high heat resistance are used for insulators holding heating materials.(External Lead model can operate up to 300℃, dependent upon operating environments).
● 【Homogeneous temperature distribution】
● 【Ecologically friendly】
The terminal structure, taking advantage of the thinness of heater, is designed to be ecologically friendly adopting lead-free soldering between a lead wire and terminal.
● 【Low outgassing】
The heater products very low rate of outgas as no adhesive is used to paste insulators (polyimide films). The heater is also suitable for environments disliking siloxanes as polyimide films do not produce siloxanes, which cause conduction failure.
● 【Fast temperature】
A very thin insulator (polyimide film), 0.2mm thick (or thinner), results in a small heat capacity and thus enables a particularly fast temperature rise.
 

◼ Types

| Internal Lead model

Specification

All products listed are available in different voltages.

Heater surface temperature	250℃ in standard usage. (Depending on operating environments, operating tempertures may vary)
Voltage	~ 200V
Watt densities	① Max:1.0W/cm2 when suspended in still air ② Max:1.5W/cm2 when fitted closely to workpiece
Insulation resistance	100MΩ or more at 500V DC
Thickness	0.2mm or less(except for lead wire joint)
Heater size limitations	W20 ✕ H20mm ～ W300 ✕ H300mm
Product code	PI-A1010

| External Lead model

Specification

All products listed are available in different voltages.

Heater surface temperature	250℃ in standard usage. (Depending on operating environments, operating tempertures may vary)
Voltage	~ 200V
Watt densities	① Max:1.0W/cm2 when suspended in still air ② Max:1.5W/cm2 when fitted closely to workpiece
Insulation resistance	100MΩ or more at 500V DC
Thickness	0.2mm or less(except for lead wire joint)
Heater size limitations	W20 ✕ H20mm ～ W300 ✕ H300mm
Product code	PI-B1010

◼ Precautions when using this product

●This product is for industrial use only.
●The product is for indoor use only and not waterproof. Keep out of water or any solutions.
●Beware it may cause an abnomally high temperature and result in a premature wire breakage, if low in degree of adhesion to workpiece.
●Ask your sales representatives to consult with the case the heater use bonded to workpiece.
●Do not apply excessive external forces(traction, bending, etc) onto lead wire joint.
●Do not heat without contact to workpiece.
●Do not place heaters on top of each other when in operation.